Round-Trip Efficiency in Commercial BESS: What Irish Businesses Pay For (and Lose)

Every kWh you charge into a commercial battery comes out smaller. The size of that loss - round-trip efficiency - directly determines your arbitrage margin, self-consumption gain, and DS3 revenue.

By Smart Solar Editorial · Updated 15 May 2026 · 8 min read

Commercial battery inverter and switchgear inside an Irish industrial electrical room

If you charge a commercial battery with 100 kWh of grid power and discharge it later, you will not get 100 kWh back. You will get 85-92 kWh. The difference is round-trip efficiency (RTE), and it has a bigger impact on Irish commercial BESS economics than most facility managers realise.

What round-trip efficiency actually measures

Round-trip efficiency is the ratio of energy out at the AC meter to energy in at the AC meter, over a complete charge-discharge cycle. It bundles five separate losses:

  1. PCS conversion losses on charge (AC to DC) - typically 2-3%
  2. Battery internal resistance on charge (heat) - 1-2%
  3. Auxiliary loads (BMS, cooling, controls) - 1-3% depending on climate and duty
  4. Battery internal resistance on discharge (heat) - 1-2%
  5. PCS conversion losses on discharge (DC to AC) - 2-3%

Total: typically 8-15% lost on every full cycle. The exact figure depends on the C-rate, ambient temperature, depth of discharge and system age.

The two RTE numbers you will see in quotes

Vendors quote RTE in two different ways. Make sure you are comparing like with like.

1. DC RTE (cell or string level). Measured at the DC terminals of the battery, ignoring the inverter. Typical LFP commercial cells: 95-97%. This number flatters the system. It is useful for cell comparison but irrelevant for your business case.

2. AC RTE (system level, also called "round-trip AC-AC"). Measured at the AC side of the PCS, including all conversion and auxiliary losses. Typical 2026 commercial LFP systems: 85-92%. This is the only RTE that matters for ROI.

Tesla Megapack 2XL publishes 92% AC RTE at 0.25C. Sungrow PowerStack publishes 88-90% AC RTE at 0.5C. BYD MV cabinets land around 87-89% AC RTE depending on auxiliary load profile.

How RTE eats into your Irish business case

Take a 500 kWh BESS at an Irish hotel chain headquarters using time-of-use arbitrage. Cheap night rate 6 c/kWh, peak rate 32 c/kWh. The arithmetic looks like:

  • Daily charge: 500 kWh at 6 c = €30
  • Daily discharge gross at 32 c = €160
  • Apparent daily gross margin: €130

But at 88% RTE you only discharge 440 kWh, so daily revenue is €140.80. Daily margin = €110.80, not €130. That is 15% less than the headline calc.

Now extend to annual revenue: €110.80 × 350 cycles = €38,780 instead of €45,500. Across 10 years, the RTE loss is €67,200 - real money on a system that cost €350k.

What changes RTE in the real world

Lab numbers are measured at 25°C ambient, fresh cells, 0.5C symmetric cycle. Operational Irish RTE typically lands 1-3 points below the lab spec because:

  • Cooler ambient. Irish averages of 5-15°C are gentler on cells than 35°C in Spain, slightly improving cell efficiency but increasing auxiliary heating load on cold mornings.
  • Auxiliary loads always run. BMS, EMS, cabinet heaters, container HVAC consume 1-3% of throughput even when idle.
  • Partial cycling. Most commercial BESS in Ireland do not do clean 100% cycles. Partial cycles at low SOC are slightly less efficient.
  • Age. RTE typically drops 0.3-0.5 percentage points per year as internal resistance grows.

A well-designed quote will state RTE at end-of-warranty as well as beginning-of-life. If only the BOL figure appears, ask for both - the difference can be 2-4 points across 10 years.

RTE and DS3 revenue

EirGrid DS3 system services pay for capacity made available, not energy delivered. But aggregator settlement still strips losses out of payment formulas. A 1 MW Tesla Megapack with 92% RTE captures roughly 5-7% more net DS3 revenue per year than an equivalent 87% RTE budget system once cycling and arbitrage on top are factored in.

For a 2 MW / 4 MWh DS3 contract with Statkraft, Veri or GridBeyond, the 5-point RTE gap can equate to €15k-€25k per year - enough to justify the price premium of higher-spec hardware.

RTE and solar self-consumption

When pairing BESS with rooftop PV in Ireland, RTE determines how much PV-charged energy you actually use. If you have a 500 kWp array generating 450,000 kWh per year and 30% would otherwise be exported (135,000 kWh), a 90% RTE battery returns 121,500 kWh of that for self-consumption. An 85% RTE system returns only 114,750 kWh.

At a typical 2026 Irish commercial day-rate of 26 c/kWh vs CEG export at 20 c/kWh, the 5-point RTE gap costs you about €405 per year per 100,000 kWh exported. Over 20 years, that compounds.

How to compare RTE properly across quotes

When you receive multiple commercial BESS quotes in Ireland, build a quick comparison table:

MetricVendor AVendor BVendor C
AC RTE at 0.5C, 25°C (BOL)91%89%87%
AC RTE at end of warranty87%84%82%
Auxiliary load (kW)2.54.05.5
Cooling systemLiquidLiquidForced air
Annual aux consumption (kWh)21,90035,00048,200

A 4% RTE gap and a 26,000 kWh per year auxiliary delta is the difference between two systems that look identical on the headline kWh number.

Field-tested commissioning checklist for RTE validation

Most EPCs will not volunteer RTE measurement at commissioning. Insist on it as a contract milestone. The protocol:

  • Run three full charge-discharge cycles at the contracted C-rate (typically 0.5C for arbitrage applications) with 25 °C ± 3 °C inlet temperature.
  • Meter at the AC switchboard, not the inverter's internal counter. Use a Class 0.5S revenue-grade bidirectional meter (Iskra, Landis+Gyr E650) — internal inverter meters routinely read 1–2% optimistic.
  • Track auxiliary draw separately. The cabinet HVAC, BMS controller and EMS gateway should be on a dedicated metered circuit. Lifetime aux consumption is often 3,000–4,500 kWh/year per 500 kWh of installed BESS in Irish climate — this must be subtracted from gross RTE.
  • Document the result in the handover pack. A signed RTE statement at commissioning sets the warranty baseline. Without it, end-of-warranty degradation claims are difficult to enforce against the OEM.
  • Re-test annually. RTE drops 0.3–0.5 ppt/year is normal; faster drops indicate cell imbalance, PCS fan failure or HVAC underperformance — all of which are covered under year 1–10 workmanship warranty if caught early.

Bottom line

For Irish commercial BESS in 2026, expect 88-92% AC RTE beginning-of-life for tier-1 LFP systems (Tesla, Sungrow, BYD), and 84-88% end-of-warranty. Anything below 84% at end-of-warranty is a value-engineered system that will silently underperform your business case across its life. Always confirm AC RTE, auxiliary load, and degradation profile in writing before signing - it is the easiest line item to skip during procurement and the costliest to fix later.

Get 3 free commercial battery quotes — free and no obligation.

Frequently asked questions

What is a good round-trip efficiency for a commercial BESS?

For modern LFP commercial battery systems in Ireland, target 88-92% AC RTE beginning-of-life and 84-88% at end of warranty. Top-tier systems like Tesla Megapack hit 92% BOL, while budget systems may struggle to reach 86%.

Why is AC RTE lower than DC RTE?

AC RTE includes inverter conversion losses (both directions) and auxiliary loads like cooling and controls, which DC RTE ignores. AC RTE is the only meaningful number for business case analysis because it reflects what you actually pay for and receive at the meter.

Does round-trip efficiency degrade over time?

Yes. AC RTE typically drops 0.3-0.5 percentage points per year as cell internal resistance grows. A system rated 90% BOL often reaches 85-86% by year 10. Always look at the end-of-warranty RTE spec, not just the headline.

How does ambient temperature affect BESS efficiency in Ireland?

Irish climate (5-15°C average) is generally favourable for cell efficiency, but increases auxiliary heating loads on cold mornings. Net impact is typically neutral compared with 25°C lab conditions. Hot summer days above 25°C trigger HVAC cooling and reduce RTE by 1-2 points.

Does higher C-rate reduce round-trip efficiency?

Yes. Each step up in C-rate from 0.25C to 0.5C to 1C to 2C typically reduces AC RTE by 2-4 percentage points due to increased internal resistance losses. DS3 fast frequency response operation runs at higher C-rates and accepts the efficiency hit.

Sources & further reading