Heat Pumps for Irish Offices: VRV, BER B and Tenant Demand

Dublin office tenants are increasingly demanding BER B and renewable heating as a lease prerequisite. Here is the 2026 playbook for landlords retrofitting heat pumps into Irish office stock.

By Smart Solar Editorial · Updated 18 May 2026 · 11 min read

Tenant demand is now driving Irish office heat pump retrofit

The Dublin office market has decisively shifted on heating in 2024–2026. Major Irish office tenants — Microsoft, Google, Meta, AIB, Bank of Ireland, ESB, Deloitte, PwC — now write BER B or better and renewable-heated into lease specifications. Sustainability-conscious tenants increasingly include WELL Building Standard or LEED Gold targets that effectively prohibit fossil-fuel heating.

For office landlords, this has reframed the heat pump conversation:

  • In 2020: "Will the heat pump pay back?"
  • In 2026: "If we do not install a heat pump, what is the lease discount and refinancing penalty?"

Irish institutional landlords (Hibernia REIT, IPUT, Iput Real Estate, Yew Grove, Henderson Park) now treat heat pump retrofit as a defensive capital programme to protect tenant retention and asset value, not a discretionary sustainability initiative.

Office heat pump architectures in 2026

Three dominant architectures serve the Irish office sector:

1. VRV/VRF heat recovery — the multi-tenant default

VRV (Daikin) and VRF (Mitsubishi, Toshiba, LG) systems are the dominant architecture for Irish multi-tenant offices. The 2026 generation — Daikin VRV 5, Mitsubishi City Multi R2 — delivers:

  • Simultaneous heating and cooling across different zones via a refrigerant heat recovery loop (perimeter zones heating, core cooling)
  • Modular condenser units in 14–28 kW increments, scaling to 150 kW per system
  • Individual zone control from desk-level wired or wireless controllers
  • Refrigerant R32 or R454B with 2026–2028 migration to R454B for higher GWP-class buildings

VRV/VRF is particularly efficient in Irish offices because simultaneous heating and cooling demand is high — perimeter east-facing zones often need heating while core zones need cooling on a typical autumn morning.

2. Air-to-water LPHW — the institutional choice

Air-to-water heat pumps feeding low-pressure hot water (LPHW) circuits to underfloor heating or fan coil units are the choice for owner-occupied corporate offices and government buildings:

  • Lower refrigerant charge (better F-gas profile)
  • Conventional radiators or UFH on the secondary side
  • Easier integration with existing plant
  • Better serviceability profile

The Office of Public Works (OPW) has standardised on air-to-water LPHW heat pumps for government office retrofits, with R290 increasingly specified for new tender packages.

3. Hybrid heat pump plus gas — the transitional play

Some larger Dublin and Cork offices have specified hybrid systems: a heat pump sized to 70–85% of design load with the existing gas boiler retained for peak-load top-up. This delivers 85–95% of the carbon reduction at 60–70% of full heat pump capex, and is a credible transitional architecture for buildings where full electrification is constrained by ESB Networks capacity.

Sizing an Irish office heat pump

Indicative sizing for typical Irish office configurations:

  • Small Class B office, 1,000 m², BER C: 60–95 kW
  • Mid-size Class A office, 3,000 m², BER B: 130–200 kW
  • Large multi-tenant office, 8,000 m², BER A3: 300–450 kW
  • Corporate campus, 25,000 m², BER A2: 800–1,200 kW (often multiple VRV systems plus central plant)

DHW load is typically negligible in office buildings (5–10% of total), unlike hotels and care homes. This means SCOP-friendly low flow temperatures (W35–W45) are easier to maintain.

2026 installed pricing for Irish offices

  • 1,000 m² office, 80 kW system: €65,000–€115,000 installed
  • 3,000 m² office, 180 kW VRV system: €170,000–€280,000 installed
  • 8,000 m² office, 400 kW VRV system: €350,000–€560,000 installed
  • 25,000 m² campus, 1,000 kW combined system: €750,000–€1,200,000 installed

EXEED grant typically captures 25–30% of eligible capex on office retrofits, with strong outcomes on gas-replacement projects because of long operating hours (typically 2,800–3,200 hours per year for Dublin offices).

BER B is the hard ceiling

Achieving BER B on existing Irish office stock is impossible with gas heating in most cases. NEAP, the non-domestic BER methodology, weights primary energy heavily and treats grid-electricity heat pumps favourably as the Irish grid decarbonises. Indicative BER outcomes:

  • 2005-era office with gas boilers and fan coils: typically BER C2 (best case C1)
  • Same building with air-to-water heat pump and unchanged fabric: BER B3 or B2
  • Same building with heat pump plus modest fabric upgrades: BER B1 or A3

The single largest BER lever an Irish office landlord controls in 2026 is heating fuel. Heat pump alone moves the rating one to two BER grades. Combined with LED relamping, control upgrades and modest insulation, BER B is achievable on most 1995-onwards Irish office stock.

ESB Networks capacity is the practical constraint

The single most common practical constraint on Dublin office heat pump retrofit is ESB Networks supply capacity. A 200 kW heat pump system draws roughly 70 kW of additional electrical load (typical SCOP 3 design point). Many 1990s and early-2000s Dublin office buildings were specified with 250–400 kVA supply for fan-coil air conditioning and lighting only.

Practical implications:

  • ESB Networks load assessment should be the first procurement step
  • Supply upgrade can take 9–18 months and cost €30k–€150k depending on transformer and ductwork requirements
  • Demand-side management (DSM) and on-site PV can sometimes avoid the upgrade
  • Soft-start and load-shedding controls are now standard on commercial heat pumps to ease supply-side impact

Acoustic and planning constraints

Dublin city centre rooftop installations face increasingly tight acoustic constraints:

  • South Dublin and Dun Laoghaire-Rathdown: 45 dB(A) at nearest residential receptor (1 m)
  • Dublin City Council: 40 dB(A) night-time (23:00–07:00) at residential receptors
  • Planning permission required for rooftop installations visible from the public road in conservation areas (which covers much of Dublin's central business district)

Acoustic enclosures (€8k–€25k per system) and careful unit placement are now standard.

Notable Irish office heat pump projects

  • Sir John Rogerson's Quay 70 (Dublin): 800 kW Daikin VRV 5 retrofit, BER B2, commissioned 2024
  • One Microsoft Place, South County Business Park: full heat pump campus design
  • Capital Dock (Dublin): 1.2 MW combined VRV plus river-source heat pump
  • The Maple Building, Cork: 320 kW Mitsubishi City Multi R32, retrofit from gas, EXEED-certified

Procurement timeline for an Irish office retrofit

A pragmatic 14–18 month timeline:

  1. Month 1–2: Energy audit, ESB Networks capacity assessment, EXEED feasibility
  2. Month 3–5: Stage 3 MEP design, EXEED application, tender preparation
  3. Month 6–7: Tender, supplier evaluation, contract award
  4. Month 8: ESB Networks supply upgrade (if required) — can extend timeline
  5. Month 9–13: Installation, typically phased outside tenant working hours
  6. Month 14–16: Commissioning, SPF verification, BER recertification
  7. Month 17–18: EXEED grant claim and ACA capital allowance

Office heat pump retrofit is now table-stakes for Irish commercial landlords. The combination of tenant demand, refinancing pressure, EXEED grant capture and ACA tax shield delivers a defensible business case on virtually every BER C and below office building in the Dublin and Cork markets.

Get 3 free commercial heat pump quotes — free and no obligation.

Frequently asked questions

Will tenants pay more for a heat pump office in Dublin?

Indirectly, yes — BER B and renewable-heated office stock now achieves typically 5–12% lower void rates and 8–15% rental premia versus BER C gas-heated comparables in the Dublin Class A and B+ market. Major corporate tenants increasingly write BER B into lease specifications.

Can I retrofit a heat pump into a 1990s Dublin office?

Yes, but ESB Networks supply capacity is often the binding constraint. A 200 kW heat pump adds roughly 70 kW of electrical load, which often requires supply upgrade. Plan 9–18 months for the upgrade and €30k–€150k of additional capex.

What is the best heat pump architecture for a multi-tenant office?

VRV/VRF with heat recovery is the dominant choice — Daikin VRV 5 or Mitsubishi City Multi R2. They handle simultaneous heating and cooling demand (perimeter heating while core cools) very efficiently and provide individual tenant zone control. Typical SCOP 3.4–3.8 in Irish conditions at W45.

How much does an office heat pump cost in Ireland?

Indicative 2026 installed pricing: €65k–€115k for 1,000 m² (80 kW), €170k–€280k for 3,000 m² (180 kW VRV), €350k–€560k for 8,000 m² (400 kW VRV). EXEED grant typically captures 25–30% of eligible capex, with ACA providing 100% first-year capital allowance on the balance.

Sources & further reading